|
1-Piece Twist-On
Step 1
Strip cable as shown. Take care not to nick center conductor or outer braid.
Step 2
Twist outer braid in a clockwise direction so that at least 1/32" of cable dielectric is bared, and braided is left flat. (Stray or loose braid can cause shorts.
Step 3
Gently insert center conductor into back end connector, "feeling" it into the guide hole. (If center conductor is NOT properly in place, about 1/8" of
center conductor will show at the back end. Reinsert untile cable dielectric reaches position shown in illustration.)
Step 4
Push the cable firmly home (as far as possible). Then screw the connector onto the cable in a clockwise direction unitl it stops. Assembly is complete.
2-Piece Crimp-On
Step 1
Strip cable jacket, braid, and dielectric as shown. All cuts are to be sharp and square. Important: Do not nick braid, dielectric, and center conductor.
Slide outer ferrule onto cable as shown.
Step 2
Flare slightly end of cable braid as shown to facilitate insertion of inner ferrule of connector. Important: Do not comb out braid.
Step 3
Install cable assembly into body assembly so that inner ferrule portion slides under braid. Slide outer ferrule over braid and up against connector body. Crimp outer ferrule.
3-Piece CRIMP-On
Step 1
Strip cable jacket, braid and dielectric as shown. All cuts are to be sharp and square. Important: So not nick braid,
dielectric, and center conductor. Slide outer ferrule onto cable as shown
Step 2
Flare slightly end of cable braid as shown to facilitate insertion of inner ferrule of connector. Important: So not comb out braid.
Place male contact on cable center conductor so that it butts against cable dielectric.
Step 3
Install cable assembly into body assembly so that inner ferrule portion slides under braid. Push cable assembly forward until
contact snaps into place un insulator. Slide outer ferrule over braid and up against connector body. Crimp outer ferrule.
|
|
© 2002 Dolphin Components Corp. All Rights Reserved